How To Fix A Garage Door That Goes Back Up

A garage door is one of the least appreciated mechanical devices. Without thinking about it, we expect this giant door that can weigh hundreds of pounds to open and close on demand with the simple push of a button on our wall, car or phone. We want to be able to access our vehicles and belongings whenever we want, but we also want to be able to store them safely behind the door. Many of us don't carry a key to our front doors anymore as the garage door is the main access point for the family to get in and out of the house.

When our garage door doesn't work normally, we realize how much we depend on it. When you try to close the garage door it won't stay closed, that's one of the more frustrating things. Instead it gets to the bottom, closed position, then reverses directions and opens up again. This can be very frustrating. It makes you wonder, How To Fix A Garage Door That Goes Back Up. No one wants their garage door to be open.

The most common reason for this happening is that it can be easily fixed without the need for a professional garage door repair service. At some point, you'll need to decide if you want to handle it yourself, or if you want to get it done right the first time and not have to worry about it.

Why is the garage door not closing?

This sounds familiar to me? Is this true? When you were a kid, you and your siblings would close the garage door and run under it to get out. Thanks to two tiny photo eyes on either side of the garage entrance, any garage door that was installed after 1993 is no longer very easy to pull off. The invisible beam between the photo eyes is used to detect if something is in the path of a garage door. Automatic garage doors can close on top of someone, so there is a safety measure in place.

If the door isn't closing, the first thing you should do is check the beam between the two photo eye sensors.

Near the bottom of your garage doors you can find a motion detector. The device looks for movement in the area covered by the light beams. The lights will go out temporarily when something moves into the path of the beams. To keep your garage doors open, you have to clean them regularly. Make sure there isn't anything blocking the beam. The eyes should be pointed at each other to create a connection.

These sensors can be bumped out of position, or partially blocking one of them. It can be anything from a trash can to a leaf or an accumulate of dirt. The door will return to the open position if the two sides are unable to connect via the beam.

If this is the reason your door isn't closing, this is good news

The door is working as it should. There is nothing wrong with your door, its built in safety system is working to protect you and your belongings from accidentally getting crushed by the door as it comes down, in the event there is something in its path and shouldn't be

This is a very easy fix that can be done in a matter of minutes. Get the sensors lined up correctly so that they don't get in the way. It's easy Peasy.

Things may be a bit more complicated if your garage door isn't closing and you have garage door sensors on.

You may have to adjust the limit switch

The limit switch is one of the most common reasons for a garage door to go back up. The garage door stops when the limit switch is turned on. The safety mechanism will kick in and open the door if there is something in the way. Adjusting your limit switch with a flathead screwdriver is a good idea if this is the case. The limit switch needs to be set correctly. The travel module in your garage is responsible for controlling how far the garage door travels. If your garage door stops working, it's time to check the travel module. A broken travel module can cause the garage door to stop functioning altogether. If needed, replace the module.

The Logic Board may need to be replaced

The garage door is controlled by a logic board. A damaged logic board can cause the garage door to malfunction. You can replace the logic board yourself, but more often than not, considering the number of other parts in a opener, you're better off buying a new unit, otherwise you'll end up throwing good money after bad. Ask a garage door service company for their recommendations.

Looking for help with garage door openers?

Cleaning of the safety sensors is very easy, but other issues such as limit setting can be more difficult. There are things that are outside the realm of what an average homeowner should do. It's best to call a garage door professional.

If you don't consider a garage door to be a highly technical part of your home, you may not know that it can have dozens of moving parts. If you don't know how garage door components all work together, then you don't think they play an important role. Trust us when we say that you shouldn't be fixing your own garage door.

The time, money, frustration and potential serious bodily injuries you could save by simply calling in a garage door professional, such as Discount Door Service, who has been providing garage door repair in Tucson, AZ since 1999, is significant.